Clock Summer-Time - HP MSR Series Command Reference Manual

Parameters
none: Uses the local system time that is configured by using the clock datetime, clock timezone, and
clock summer-time commands.
ntp: Uses the NTP time source. When the device uses the NTP time source, you cannot change the system
time manually. For more information about NTP, see Network Management and Monitoring
Configuration Guide.
Usage guidelines
If you configure this command multiple times, the most recent configuration takes effect.
Examples
# Configure the device to use the local system time.
<Sysname> system-view
[Sysname] clock protocol none

clock summer-time

Use clock summer-time to configure the device to use daylight saving time during a specific period of
time.
Use undo clock summer-time to cancel the configuration.
Syntax
clock summer-time name start-time start-date end-time end-date add-time
undo clock summer-time
Default
Daylight saving time is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
name: Specifies a name for the daylight saving time schedule, a case-sensitive string of 1 to 32
characters.
start-time: Specifies the start time in the format hh:mm:ss. The hh value is in the range of 0 to 23. The mm
value is in the range of 0 to 59. The ss value is in the range of 0 to 59. The leading zero in a segment
can be omitted. If the seconds segment is 0 (hh:mm:00), you can omit it. If both the minutes and seconds
segments are 0 (hh:00:00), you can omit both of the segments. For example, to specify 08:00:00, you
can enter 8.
start-date: Specifies the start date in one of the following formats:
MM/DD. The MM value is in the range of 1 to 12. The value range for DD varies by month.
•
month week date, where:
•
month—Takes January, February, March, April, May, June, July, August, September, October,
November or December.
week—Represents week of the month. It takes first, second, third, fourth, fifth, or last.
209