Transferring Data Sets From The Controller To The Terminal; Transferring Data Sets From The Terminal To The Controller; Transferring Data Sets From The Controller To The Terminal (Individually) - Omron NT4S Operation Manual

Standard Mode

4.23.3 Transferring Data Sets from the Controller to the Terminal

4.23.4 Transferring Data Sets from the Terminal to the Controller

4.23.5 Transferring Data Sets from the Controller to the Terminal
(Individually)
174
The following hex code can be used from the controller to initiate the transfer of a
data set from the controller to the operating terminal. This requires that the recipe
number and data set number are specified by the controller first.
The data sets are transferred as a block.
The following variables must be defined:
- Recipe number for the Request from Controller (System Parameters: Data Set
Transfer)
- Data set number for the Request from Controller (System Parameters: Data Set
Transfer)
Hexadecimal code:
The following hex code can be used from the controller to initiate the transfer of a
data set from the operating terminal to the controller. This requires that the recipe
number and data set number are specified by the controller first.
The following variables must be defined:
- Recipe number for the Request from Controller (System Parameters: Data Set
Transfer)
- Data set number for the Request from Controller (System Parameters: Data Set
Transfer)
Hexadecimal code:
The following hex code can be used from the controller to initiate the transfer of a
data set from the controller to the operating terminal. This requires that the recipe
number and data set number are specified by the controller first.
The data sets are transferred individually.
The following variables must be defined:
- Recipe number for the Transfer from the terminal (System Parameters: Data
Set Transfer)
- Data set number for the Transfer from the terminal (System Parameters: Data
Set Transfer)
Hexadecimal code:
7FFA
H
7FFB
H
7FFD
H
Section 4-23