Omron NT4S Operation Manual page 157

Standard Mode
. . . . . . . . A self-test is performed when the terminal is
switched on. This error message is generated if
a key is pressed while the keyboard is being
checked. Please release the key. If this mes-
sage appears when no key is pressed, the
message indicates a defective keyboard!
. . . . . . . . When the terminal is switched on, all messages
in the terminal are sorted. This initialization proc-
ess requires a certain length of time based on
the number of stored messages. The message
is always generated, but is only displayed for a
very short time period or is not visible at all.
. . . . . . . . Is displayed while the mask memory is being
erased. All of the programmed data are erased
at this point.
. . . . . . . . This message indicates that the Flash has
been erased. SER2 is initialized for the down-
load mode.
. . . . . . . . The operating terminal indicates that it is ready
for a download with a baud rate of 19200 Bd
via SER2. A new project can now be loaded or
new interface parameters for the transfer can
be exchanged.
. . . . . . . . The operating terminal indicates that it is ready
for a download with the new interface parame-
ters. If no data are received within 20 s, the op-
erating terminal will return to the DOWNLOAD
1 condition.
. . . . . . . . The operating terminal will reboot within the
next few seconds.
. . . . . . . . The operating terminal reported its parameters
during the startup process:
- CPU frequency in MHz
- Size of the Flash memory in Kbytes
- Eprom version number XXXXXXXX
- Loaded PLC driver YYYYYYYY
Section 4-9
143