Omron NT4S Operation Manual page 123

Standard Mode
DSDnloadState
This variable can be used to monitor the data transfer to the controller.
Data type:
Editor:
Output:
Possible values:
LoadDSName
This variable contains the name of the last data set which has been transferred to
the controller. If the data set has already been deleted, question marks are dis-
played.
Data type:
Editor:
Output:
Possible values:
StartSave
This variable can be used to transfer data sets to the PC.
Data type:
Editor:
Output:
Possible values:
SaveState
During a transmission to the PC, this variable indicates the current status of the
transmission process.
Data type:
Editor:
Output:
Possible values:
Numeric
---
Selection text
(0) Initial state
(1) Request for data transfer issued, but not yet re-
leased by the controller
(2) Data transfer active
Alphanumeric
---
Alphanumeric
15 characters
Numeric
Selection text
---
(0) Initial state
(1) Transfer one data set to the PC
(2) Transfer all data sets of a recipe to the PC
(3) Transfer all data sets in the terminal to the PC
Numeric
---
Selection text
(0) Initial state
(1) One data set is transferred to the PC
(2) All data sets of a recipe are transferred to the
PC
(3) All data sets in the terminal are transferred to
the PC
Section 4-6
109