Omron NT4S Operation Manual page 102

Standard Mode
88
ComStopBitsA
Defines the number of stop bits for the communication via SER1.
Data type:
Editor:
Output:
Possible values:
ComBaudrateA
Defines the baud rate for the communication via SER1.
Data type:
Editor:
Output:
Possible values:
ComHandshakeA
Specifies the type of handshake for the communication via SER1.
Data type:
Editor:
Output:
Possible values:
ComDefaultA
This variable can be used to program new parameters for SER1.
Data type:
Editor:
Output:
Possible values:
Numeric
Selection text , positive decimal number
---
(0) 1 bit
(1) 1.5 Bits
(2) 2 bits
Numeric
Selection text , positive decimal number
---
(0) 300 Bd
(1) 600 Bd
(2) 1200 Bd
(3) 2400 Bd
(4) 4800 Bd
(5) 9600 Bd
(6) 19200 Bd
(7) 38400 Bd
Numeric
Selection text , positive decimal number
---
(0) No handshake
(1) RTS/CTS hardware handshake
(2) XON/XOFF software handshake
Numeric
Selection text , positive decimal number
---
(0) Inactive Initial state
(1) Active The data entered into the associated
system variables are accepted as
the new parameters.
(2) Active The data stored in the Flash memo-
ry by the programming software are
accepted as the new parameters.
Section 4-6