Preventing Pulling Of The Media With Undue Force When Performing Cutting Only - Roland VersaUV LEC-300 User Manual

5-6 Making Various Adjustments for Cutting

Press

Press

Open the front cover.

Check the results of the cutting test.
Adjustment is complete when optimal results are obtained. If further adjustment is needed, go back to step
and fine-tune the adjustment.
Description
Hardened ink is thick. This means that the cutting conditions when you're cutting a printed surface are different from the
cutting conditions when you're cutting a surface that hasn't been printed. When you're cutting a printed surface, use this
[CUT TEST PRINT] to adjust the cutting conditions.
Note: These adjustments are general suggestions. Their accuracy is not assured.

Preventing Pulling of the Media with Undue Force When Performing Cutting Only

Procedure

MENU
CUTTING MENU

CUTTING MENU
PREFEED

PREFEED
DISABLE

W 736mm
SETUP SHEET
ROLL
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds out media according to
the size of the data sent from the computer before performing cutting. This makes it unnecessary to turn the media flanges
by hand to feed out media every time you perform cutting. Note, however, that this feeds out media even when you're
performing printing only, so set it to "DISABLE" when not needed.
100 Chapter 5 Feature Reference
Press
Press
Press
Press
Press
Use
ENABLE
Press
Press
Press
.
several times.
.
several times.
.
to select "ENABLE."
to enable the setting.
.
to go back to the original screen.
4.
- 