When Performing Output Involving Pullback Movement (Or When [Tu2] Is Selected) - Roland VersaUV LEC-300 User Manual

When Performing Output Involving Pullback Movement (or When [TU2] Is Selected)

When Performing Output Involving Pullback Movement (or When [TU2] Is Selected)
SETUP SHEET
TU2
Never pull the media with excessive force.
If the media is pulled forcedly, it may result in interruptions during output or inaccuracy of output locations.
When using the media take-up system, to avoid pulling media with undue force, be sure to observe the fol-
lowing points.
 Never operate the MANUAL switch for the take-up unit when the loading lever is pulled back.
 Never press
 Be sure to set the base point when the media is moved forward by pressing
the media is completed.
 Set 120mm or more on the computer for the margin from the output end location to the next output start
location (or the space between the pages).
When Performing Continuous Printing of Two or More Pages
When you're performing continuous printing and take-up for two or more pages, give attention to the fol-
lowing points.
 If the setting to execute automatic cutoff of the media can be made on the computer, then turn this setting
off. Making the setting on the computer to execute automatic cutoff of the media results in media cutoff
after each page is printed. Take up quits as soon as the media is cut off.
Movement until the media has been set with [TU2] selected
With [TU2] selected, the media will be fed out until the dancer roller leans down to the front com-
pletely.
Operation till the media is taken up when [TU2] is selected
The media is not taken up during output. When output is finished, the media is pulled back to a given
position, and the taking-up operation starts.
About Length Output At One Time
If the length of output at one time is too long, the media may get soiled by touching the work floor. To avoid
the media from getting soiled by touching the floor, output the media by about 300 mm. To output by limiting
the length, use the function of RIP software.
 The setting method when using Roland VersaWorks is continued on next page.
In using the media take-up system to perform output involving pullback move-
ment, select [TU2] of the [SETUP SHEET] menu. For the operations after selecting
[TU2], follow the instructions described in "Using the Media Take-up System" of
the User's Manual.
When [TU2] is selected, follow the below instructions.
to pull the media back.
after the setting of
15