Fax Settings; Selecting The Type Of Telephone Line; Setting The Display Language - Canon imageRUNNER ADVANCE C5051 Getting Started

Fax Settings

This section describes the important setting registrations and procedures that must be done before the machine is used for
sending operations.
If you attempt to use the machine without registering the necessary information correctly, the machine may not function properly.
•
To send a fax, the FAX Board or the Remote Fax Kit must be available for use.
•
This section describes the settings when the FAX Board is attached to the machine.
•
For information on the settings when the Remote Fax Kit is used, see "Remote Fax Settings, " on p. 13-7.

Selecting the Type of Telephone Line

Set the type of telephone line that is connected to the machine.
To set the type of telephone line connected to the machine with the FAX Board installed, check whether it is a rotary dial
(rotary pulse) or a touch-tone type and make the correct setting.
If the Super G3 2nd Line Fax Board is installed in addition to installing the Super G3 FAX Board, or the Super G3 3rd/4th Line
Fax Board is installed in addition to installing the Super G3 2nd Line Fax Board and Super G3 FAX Board, perform the same
registration procedure for the additional line, too. (See e-Manual >Settings/Registration.)
The telephone line type you can select here is for line 1. To select the telephone line type for an additional line, see e-Manual >Settings/
Registration.
1
Press
[Line 1] → [Select Line Type] .
2
Select the type of telephone line → press [OK] .
13
If you do not know the telephone line type, call your telephone service provider for details.

Setting the Display Language

If you decide to switch the display language, set [Language/Keyboard Switch On/OFF] to 'On' before entering characters.
If [Language/Keyboard Switch On/OFF] is set to 'Off' , and then you set it to 'On' after entering characters, the characters may
not be displayed correctly. In this case, either re-enter the characters after setting [Language/Keyboard Switch On/OFF] to
'On' , or enter characters with [Language/Keyboard Switch On/OFF] set to 'Off' .
If [Language/Keyboard Switch On/OFF] is set to 'On' , some characters are restricted and cannot be entered. (See e-Manual >
Settings/Registration.)
13-2

Fax Settings

(Settings/Registration) → [Function Settings] → [Send] → [Fax Settings] → [Set Line] →