●
If you want to deny transmission/reception of data with the computer having the specified IPv6 address:
☐
Press [TX Filter] or [RX Filter] → set <Use Filter> to 'On' .
☐
Set < Default Policy > to [Allow].
☐
Press [Register] → set the IPv6 address for which data transmission/reception is to be denied, or specify the prefix and prefix
length of the IPv6 address(es).
If data transmission/reception is attempted between the device having the IPv6 address specified in this procedure and the
machine, a block log will be generated. To display the block log, see e-Manual > Network.
●
If you want to allow transmission/reception of data only with the computer having the specified IPv6
address:
☐
Press [TX Filter] or [RX Filter] → set <Use Filter> to 'On' .
☐
Set < Default Policy > to [Reject].
☐
Press [Register] → set the IPv6 address for which data transmission/reception is to be allowed, or specify the prefix and prefix
length of the IPv6 address(es).
●
If you do not want to restrict data transmission/reception:
☐
Press [Send Filter] or [Receive Filter] → set <Use Filter> to 'Off' .
•
You can register up to 16 IPv6 addresses, or IPv6 address prefixes.
•
You cannot specify a multicast address for an IPv6 address.
•
If the usage of a protocol or print application is not permitted on your device, it cannot be used even after settings in [Firewall
Settings] have been changed; on your device, configure the settings to permit the protocol or print application.
•
If you enter '255' in [Prefix Length], no IPv6 addresses will be set.
•
If you enter '0' in [Prefix Length], all IPv6 addresses will be set.
4-11
Protocol Settings
4