Send Tx Report/Send Error Tx Report - Canon imageRUNNER ADVANCE C5051 Getting Started

Send TX Report/Send Error TX Report

The Send TX Report is a printed report that informs you of whether a send job has been successfully delivered to its
destination. A Send TX Report can be set to print automatically after each job is sent, or only when there are transmission
errors. (See e-Manual > Settings/Registration.)
•
A list of fax, e-mail, I-fax, file server, and Mail Box transmissions is printed on the Send TX Report. Even if [Report with TX Image] is set to
'On' , the contents of the sent document are not printed on the report if the document was sent using the Encrypted PDF mode.
•
You can also print a Send TX Report with an image of the sent original attached to it. (See e-Manual > Settings/Registration.)
■ JOB NO .
The four digit number, that is automatically assigned when the document is accepted for sending, is printed.
■ DEPT . ID
If Department ID Management is set, the Department ID is printed.
■ ST . TIME (Start Time)
The date and time (in 24-hour notation) at which the document started to transmit are printed.
■ PGS .
The number of pages that were sent is printed.
■ SEND DOCUMENT NAME
The name given to the document when the send settings were specified is printed.
■ TX/RX INCOMPLETE
If the transmission has been interrupted, the name and address of the destination are printed.
■ TRANSACTION OK
If the transmission completed successfully, the name and address of the destination are printed.
■ ERROR
If a sending error occurs, the name and address of the destination are printed.
If a field exceeds its display capacity, only those characters that fit in the display are printed.
17
17-6
Reports