Napoleon LVX38N Installation Manual page 60

finishing
EN
Check if the outer glass of the GGA is touching the heat rail gasket on both ends.
13.
Check for any excessive play by lightly pulling the GGA outwards. The play (rattle / movement) should be
14.
negligible in the system when the GGA is held in position by the safety clips.
If there is excessive play, the latch clips on the bottom of the GGA should be adjusted to reduce the play to a
15.
minimal level. This is to ensure GGA can still be clipped and unclipped smoothly without excessive force.
Recheck the outer glass alignment to the heat rail gasket and adjust if needed.
16.
Safely store the GGA after test fitting. Ensure GGA is placed on a non-abrasive material to avoid scratches.
17.
Re-install GGA after the appliance finishing and recheck alignment.
18.
To remove GGA
To open, release the safety clip from the GGA using the release tool. Push the release tool against bottom
of safety clip until it disengages from GGA. Pull gently on GGA while releasing the safety clip latch.
Pull both sides of GGA keeping it parallel to the appliance.
60
W415-1710 / A / 07.27.17