12.4 glass guard installation / removal
note:
The glass guard assembly (GGA) installation and/or removal will require 2 people.
important:
The Glass Guard Assembly (GGA) must be fitted before finish framing and finishing the appliance.
Unpack the Glass Guard Assembly (GGA) and keep packaging materials to store the GGA after test fitting.
1.
Note:
The polystyrene may scratch the glass if it is not covered by a plastic bag. Retain other packaging
materials if desired for temporary storage.
Ensure to handle the GGA as shown below as the floating intermediate glass might fall out of the assembly if
2.
handled incorrectly.
For ease of installation, remove the access panel, door trim, and control cover.
3.
Intermediate Glass
Access Panel
Door Trim
GGA
Outer Glass
Control Cover
finishing
EN
55
W415-1710 / A / 07.27.17