Napoleon LVX38N Installation Manual page 59

Slide GGA into the appliance until outer glass panel makes contact with heat rail gasket. The GGA will
10.
'click' into safety latches when secure. If GGA does not engage with safety clips, an adjustment may be
required.
important:
Ensure that the heat rail gasket is touching the both ends of the back of the outer glass as shown
Heat Rail
Gasket
Outer Glass
SIDE VIEW
For longer appliances, the glass pieces may look slightly bowed (illustration not to scale) when the glass and
appliance are cold. This is normal and not a cause for concern. The glass will straighten and become flush to
the heat rail gasket as it comes warm when the appliance is operating
It is REQUIRED to have the gasket touching both ends of the outer glass.
Check if the GGA plane is straight. Adjust with horizontal adjustment screws if necessary.
11.
Check if the safety latches are correctly positioned. Adjust safety latches if necessary.
12.
Outer Glass
The gasket MUST touch the back of
the outer glass at both ends.
Safety Latch
too high - won't
disangage
Heat Rail
Gasket
Intermediate Glass
Safety Latch
too low - won't
engage
W415-1710 / A / 07.27.17
finishing
EN
59