Install The M.2 Backplane And M.2 Drive - Lenovo ThinkSystem SR650 Maintenance Manual

Figure 132. M.2 retainer adjustment
Step 1. Press both sides of the retainer
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.

Install the M.2 backplane and M.2 drive

Use this information to install the M.2 backplane and M.2 drive.
Before installing the M.2 backplane and M.2 drive:
1. Touch the static-protective package that contains the new M.2 backplane and M.2 drive to any
unpainted surface on the outside of the server. Then, take the new M.2 backplane and M.2 drive out of
the package and place them on a static-protective surface.
2. Adjust the retainer on the M.2 backplane to accommodate the particular size of the M.2 drive you wish
to install. See "Adjust the retainer on the M.2 backplane" on page 168.
To install the M.2 backplane and M.2 drive, complete the following steps:
1 .
Chapter 3
.
Hardware replacement procedures
169