Install The Serial Port Module - Lenovo ThinkSystem SR650 Maintenance Manual

Watch the procedure. A video of the removal process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1. Disconnect the cable of the serial port module from the system board.
Step 2. Open the retention latch and remove the serial port module from the chassis.
Figure 128. Serial port module removal
After removing the serial port module:
1. Install a new serial port module, a PCIe adapter, or a PCIe slot bracket to cover the place.
2. If you are instructed to return the old serial port module, follow all of the packaging instructions and use
any packaging materials that are provided.

Install the serial port module

Use this information to install the serial port module.
Before installing the serial port module:
1. If the slot is covered with a slot bracket, open the retention latch and remove the slot bracket from the
chassis. Store the bracket in case that you later remove the serial port module and need the bracket to
cover the place.
2. Touch the static-protective package that contains the new serial port module to any unpainted surface
on the outside of the server. Then, take the new serial port module out of the package and place it on a
static-protective surface.
To install the serial port module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
Step 1. Install the serial port module into the chassis and close the retention latch to secure it in position.
.
Chapter 3 Hardware replacement procedures
165