Lenovo ThinkSystem SR650 Maintenance Manual page 132

Before installing a hot-swap drive:
1. If the drive bay has a drive filler installed, pinch the two tabs to remove the drive filler. Keep the drive filler
in a safe place.
Figure 93. 2.5-inch drive filler removal
Figure 94. 3.5-inch drive filler removal
2. Touch the static-protective package that contains the new drive to any unpainted surface on the outside
of the server. Then, take the new drive out of the package and place it on a static-protective surface.
To install a hot-swap drive, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
124
ThinkSystem SR650 Maintenance Manual