Install The Serial Port Module - Lenovo ThinkSystem SR650 Series Setup Manual
Hide thumbs
Also See for ThinkSystem SR650 Series:
- Maintenance manual (244 pages) ,
- Product manual (87 pages) ,
- Quick start manual (14 pages)
Table of Contents
Advertisement
page 126
Before installing the LOM adapter:
1. If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case
that you later remove the LOM adapter and need the bracket to cover the place.
CAUTION:
Use a tool to remove the LOM adapter slot bracket to avoid injury.
2. Lift the LOM-adapter air baffle out of the chassis.
3. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Watch the procedure. A video of the installation process is available:
Figure 104. LOM adapter installation
Step 1.
Place the LOM adapter into the connector at an angle.
Step 2.
Rotate the LOM adapter down.
Step 3.
Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4.
Tighten the thumbscrew to secure the LOM adapter.
Step 5.
Align the mounting stud on the chassis with the hole in the LOM-adapter air baffle. Then, pinch the
tab
1
and lower the LOM-adapter air baffle onto the LOM adapter.
Install the serial port module
Use this information to install the serial port module.
page 126
page 194
this task" on
page 194
"ATTENTION:
on page 127
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 127
.
Chapter 3
Server hardware setup
175
Hide quick links:
Advertisement
Chapters
Table of Contents
