Lexus LC500 2017 Owner's Manual page 308

308
6-3. Do-it-yourself maintenance
3 Press or
trol switches and select "Vehicle
Settings", then press "OK".
4
Press or
trol switches and select "TPWS
SET", then press "OK".
5
Press or
trol switches and select "Change
wheel set". Then press and hold
"OK" until the tire pressure warning
light starts blinking.
The change wheel set mode is activated
and registration is started.
A message is displayed on the multi-infor-
mation display, and "--" is displayed for
inflation pressure of each tire. Then, the tire
pressure warning light blinks rapidly for
approximately 1 minute and stays on.
6
Drive the vehicle at 25mph (40
km/h) or more for approximately
10 to 30 minutes.
When registration is completed, the tire
pressure warning light will go off and the
inflation pressure of each tire will be dis-
played on the multi-information display.
The time elapsed before registration is
completed differs according to the driving
condition and environment.
Canceling the change wheel set mode
■
● If turning the engine switch <power
switch> off when in the change wheel set
mode before driving, the change wheel
LC500_LC500h_OM_OM11405U_(U)
of the meter con-
●
of the meter con-
●
of the meter con-
■
●
●
●
If registration takes long time, perform the
procedure for ID code registration again
after parking the vehicle for 20 minutes.
If the ID codes cannot be registered even
when performing the above procedure,
contact your Lexus dealer.
set mode is canceled.
After driving when in the change wheel
set mode, the change wheel set mode
cannot be canceled. To cancel the mode,
perform the procedure for ID code regis-
tration again and turn the engine switch
<power switch> off before driving.
If the change wheel set mode is canceled,
the ID codes that have already been reg-
istered are communicated. When com-
munication is finished, the tire pressure
warning light will turn off.
When ID code registration may not
operate properly
Do not move the vehicle backward
during registration. Registration is started
again from the beginning and it may take
longer than usual.
When another vehicle is running the side
of the vehicle such as in heavy traffic, it
may take longer to detect the vehicle's
tire pressure warning valves and trans-
mitters.
If tire pressure warning valves and trans-
mitters are in the vehicle, the ID codes
may not be registered.