Lexus LC500 2017 Owner's Manual page 263

holding the programmed Home-
®
Link button for 2 seconds and
then release the button.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
Perform 3 within 30 seconds after per-
LC500_LC500h_OM_OM11405U_(U)
5-6. Using the other interior features
forming 2.
®
buttons.
3 Press and hold the desired Home-
Link
for 2 seconds and release it. Repeat
this sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor operates
when the HomeLink
the garage door opener motor recognizes
the HomeLink
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
device compatibility, refer to
®
button (inside the vehicle)
®
button is pressed,
®
signal.
263
5