Figure 2-4 Networking Diagram Of Outputting Logs To The Log File - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Networking Requirements
As shown in
server so that maintenance engineers can easily obtain the operation status of Switch A and
locate the faults occurring on Switch A.

Figure 2-4 Networking diagram of outputting logs to the log file

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Configure the routing protocol to make the switch and the FTP server reachable. (The detailed
procedure is not mentioned here.)
Step 2 Configure the channel used to output logs.
# Enable the information center.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] info-center enable
Step 3 Configure the logs to be output through the channel.
Issue 01 (2010-12-15)
Figure 2-4, Switch A is required to transport logs to a File Transfer Protocol (FTP)
10.2.1.1/16
GE1/0/1
Enable the information center.
Configure the contents of the logs to be output.
Configure the channel through which logs are output.
Set logs to be output to the FTP server.
IP address of each interface
Information channel number
Module enabled to output logs
Severity levels of logs
Language in which logs are output
IP address of the FTP server
User name and password of the FTP server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IP network
FTP Server
10.1.1.1/16
2 Information Center Configuration
2-33