Example For Outputting Logs To Log Hosts; Figure 2-5 Networking Diagram Of Outputting Logs To The Log Host - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management

2.6.2 Example for Outputting Logs to Log Hosts

This part describes how to output logs of different modules or severity levels to different log
hosts, and how to configure backup log hosts for backing up logs.
Networking Requirements
As shown in
different log hosts through information channels.
switch sends the logs (with the severity level as notification) generated on the Forwarding
Information Base (FIB) module and the IP module to the log host Server 1. Server 3 functions
as a backup switch of Server 1.
switch sends the logs (with the severity level as warning) generated on the Point-to-Point
Protocol (PPP) module and the AAA module to the log host Server 1. Server 4 functions as a
backup switch of Server 2.
Both the switchs and the log hosts require to be configured.

Figure 2-5 Networking diagram of outputting logs to the log host

10.2.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
Issue 01 (2010-12-15)
Figure 2-5, it is required to output logs of multiple types and severity levels to
10.1.1.2/24 10.1.1.1/24
Server1
Server 3
Server 4
Server 2
10.2.1.1/24
Enable the information center.
Name the tunnel.
Specify the module enabled to output logs.
Configure the channel for outputting logs.
Configure the source interface that sends logs.
Configure the log host.
IP address of the log host
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/1
172.168.0.1/24
Switch
2 Information Center Configuration
2-35