Example For Configuring Binary Logs To Be Sent To The Log Host; Figure 2-7 Example For Configuring Binary Logs To Be Sent To The Log Host - Huawei Quidway S9300 Configuration Manual

2 Information Center Configuration
vlan 10
#
interface Vlanif10
ip address 172.168.0.1 255.255.255.0
#
interface GigabitEthernet1/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
ip route-static 10.1.1.0 255.255.255.0 172.168.0.2
ip route-static 10.2.1.0 255.255.255.0 172.168.0.2
#Return
2.6.4 Example for Configuring Binary Logs to Be Sent to the Log
Host
This part describes how to output logs to the log host in binary mode. Outputting logs in binary
mode can effectively lighten the network load.
Networking Requirements
As shown in
Users or maintenance personnel can analyze the log through log analysis tools and locate the
fault.

Figure 2-7 Example for Configuring Binary Logs to Be Sent to the Log Host

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need to perform the following data:
l
l
l
l
l
2-42
Figure 2-7, binary logs generated on Switch A are sent to the log host in real time.
GE1/0/1
11.1.1.1/24
Enable the information center on the switch.
Add the ID of a log to be filtered.
Generate a data dictionary and send it to the log server.
Configure binary logs to be sent to the log host.
ID of the log to be filtered
File name of the generated data dictionary
IP address of the FTP server
User name and password used for logging into the FTP server
IP address of the log host
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide - Device Management
Loghost
11.1.1.6/24
Quidway S9300 Terabit Routing Switch
Issue 01 (2010-12-15)