Table of Contents
Advertisement
Unpacking
This procedure is applied to SP C342DN only.
To protect it from shock and vibration during transit, this printer comes packaged in cushioning foam and
secured with tape. Remove the protective materials after placing the printer in the location where it will
be installed.
• The following explains the warning messages on the plastic bag used in this product's
packaging.
• Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from
babies and small children at all times. Suffocation can result if polythene materials are
brought into contact with the mouth or nose.
• The printer weighs approximately 29 kg (64 lb.).
• When moving the printer, hold the handles located on both sides, and then lift it slowly. Lifting it
carelessly or dropping it may cause an injury.
• The removed tape is sticky. Be careful not to let the sticky side touch your skin or clothes.
• Do not grip the tray area when lifting the printer.
• Make sure that paper clips, staples, or other small metallic objects do not fall inside the printer.
1.
Remove the plastic bag.
2.
Lift the printer with two people by using the inset grips on both sides of the printer.
Lower the printer slowly and carefully to prevent getting your hands stuck.
midas-p3_com_operating_instructions_gb_00198473_eng.xml
DFP005
Unpacking
51
Draft 2016/01/18
Advertisement
Table of Contents
