Configuration; Ethernet Configuration - Ricoh PRSPC342DN1 User Manual

Table of Contents

2. Setting Up the Printer

Configuration

This section describes supported network connections and settings for IP addresses and wireless LAN

security.

Configure the printer for the network using the control panel.

After configuring network settings, you can print the configuration page to confirm the settings. For

details, see page 100 "Test Printing".

• Contact your network administrator for information about configuring network settings.

• For details about setting items and their default values, see:

• page 255 "Host Interface (SP C340DN)" (for SP C340DN)

• page 291 "Interface Settings" (for SP C342DN)

• You can also use Web Image Monitor to configure the IP address-related settings. For details, see

Web Image Monitor Help.

Specifying an IP address (no DHCP)

If you want to use the printer on a network without using DHCP or want to use a static IP address, use the

following procedure to assign a specific IPv4 address to the printer. Before making any changes,

contact your network administrator to obtain the IP address, subnet mask, and gateway address to be

specified on the printer.

Press the [Menu] key, and then select the setting items using the [ ] or [ ] key.

Select [Host Interface]

Select [Network]

Select [Effective Protocol]

Select [IPv4]

Select [Active]

Set other protocols you need to set in the same way.

Select [Machine IPv4 Address]

Select [Specify]

Press [OK]

Press [Escape]

Press [OK]

Press [IP Add.]

Specify the IPv4 address for the printer

midas-p3_com_operating_instructions_gb_00198499_eng.xml

Press [OK]

Draft 2016/01/18

Table of Contents