Igmp Configuration Examples; Basic Igmp Features Configuration Examples - HP MSR1002-4 Configuration Manual

Task
Display multicast
information maintained by the IGMP proxy.
Display multicast routing entries maintained
by the IGMP proxy.
Display IGMP SSM mappings.
Clear dynamic IGMP multicast group
entries.

IGMP configuration examples

Basic IGMP features configuration examples

Network requirements
As shown in
•
OSPF and PIM-DM run on the network.
•
VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations
form stub networks N1 and N2. Host A and Host C are receiver hosts in N1 and N2,
respectively.
•
IGMPv2 runs between Router A and N1, and between the other two routers and N2. Router A
acts as the IGMP querier in N1. Router B acts as the IGMP querier in N2 because it has a lower
IP address.
Configure the routers to meet the following requirements:
•
The hosts in N1 can join only multicast group 224.1.1.1.
•
The hosts in N2 can join any multicast groups.
group membership
Figure 27:
Command
display igmp [ vpn-instance vpn-instance-name ] proxy
group [ group-address
interface-number ] [ verbose ]
display igmp [ vpn-instance vpn-instance-name ] proxy
routing-table [ source-address [ mask { mask-length |
mask } ] | group-address [ mask { mask-length | mask } ] ] *
[ verbose ]
display igmp [ vpn-instance
ssm-mapping group-address
reset igmp [ vpn-instance vpn-instance-name ] group { all |
interface interface-type
group-address [ mask
[ source-address [ mask { mask | mask-length } ] ] } }
79
| interface interface-type
vpn-instance-name
interface-number {
{ mask | mask-length
]
all |
} ]