BIDIR-PIM configuration task list
Tasks at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
(Optional.)
•
(Optional.)
Configuring a
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure BIDIR-PIM, configure a unicast routing protocol so that all devices in the
domain can interoperate at the network layer.
Enabling BIDIR-PIM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before you
enable BIDIR-PIM. As a best practice, enable PIM-SM on all non-border interfaces of routers when
you deploy a BIDIR-PIM domain.
IMPORTANT:
All interfaces on a device must be enabled with the same PIM mode.
To enable BIDIR-PIM:
Step
1.
Enter system view.
2.
Enable IP multicast routing
and enter MRIB view.
3.
Return to system view.
4.
Enter interface view.
5.
Enable PIM-SM.
6.
Return to system view.
7.
Enter PIM view.
8.
Enable BIDIR-PIM.
Enabling BIDIR-PIM
Configuring an
RP:
Enabling Auto-RP listening
Setting the maximum number of BIDIR-PIM RPs
BSR:
Configuring a C-BSR
Configuring a PIM domain border
Disabling BSM semantic fragmentation
Disabling BSM forwarding out of incoming interfaces
Configuring common PIM features
Command
system-view
multicast
[
vpn-instance
vpn-instance-name ]
quit
interface
interface-type
interface-number
pim sm
quit
pim
[
vpn-instance
vpn-instance-name ]
bidir-pim enable
112
Remarks
N/A
You must configure a static RP, a
C-RP, or both in a BIDIR-PIM
domain.
Skip the task of configuring a BSR
on a network without C-RPs.
N/A
Remarks
N/A
routing
By default, IP multicast routing is
disabled.
N/A
N/A
By default, PIM-SM is disabled.
N/A
N/A
By default, BIDIR-PIM is disabled.