Configuring Parameters For Mld Messages; Configuration Prerequisites; Configuring Source Ipv6 Addresses For Mld Messages - HP MSR1002-4 Configuration Manual

Step
2. Enter MLD-snooping view.
3. Set the maximum response
time
queries.
Configuring parameters for MLD general queries and responses in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the MLD general query
interval in the VLAN.
4. Set the maximum response
time for MLD general queries
in the VLAN.

Configuring parameters for MLD messages

This section describes how to configure parameters for MLD messages.

Configuration prerequisites

Before you configure parameters for MLD messages, complete the following tasks:
•
Enable MLD snooping for the VLAN.
•
Determine the source IPv6 address of MLD general queries.
•
Determine the source IPv6 address of MLD multicast-address-specific queries.
•
Determine the source IPv6 address of MLD reports.
•
Determine the source IPv6 address of MLD done messages.
•
Determine the 802.1p priority of MLD messages.

Configuring source IPv6 addresses for MLD messages

You can change the source IPv6 address of the MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
You can also change the source IPv6 address of MLD reports or done messages sent by a simulated
member host or an MLD snooping proxy.
To configure the source IP address for MLD messages in a VLAN:
Step
1. Enter system view.
2. Enter VLAN view.
Command
mld-snooping
for MLD general
max-response-time seconds
Command
system-view
vlan vlan-id
mld-snooping
interval
mld-snooping
max-response-time seconds
Command
system-view
vlan vlan-id
query-interval
269
Remarks
N/A
The default setting is 10 seconds.
Remarks
N/A
N/A
The default setting
seconds.
The default setting is 10 seconds.
Remarks
N/A
N/A
is 125