Configuration Prerequisites; Enabling Ipv6 Bidir-Pim - HP MSR1002-4 Configuration Manual

Tasks at a glance
Configuring a BSR
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
interfaces
(Optional.) Configuring common IPv6 PIM features
(Optional.) Enabling SNMP notifications for IPv6 PIM
(Optional.) Configuring common IPv6 PIM features

Configuration prerequisites

Before you configure IPv6 BIDIR-PIM, configure an IPv6 unicast routing protocol so that all devices
in the domain can interoperate at the network layer.

Enabling IPv6 BIDIR-PIM

Because IPv6 BIDIR-PIM is implemented on the basis of IPv6 PIM-SM, you must enable IPv6
PIM-SM before enabling IPv6 BIDIR-PIM. As a best practice, enable IPv6 PIM-SM on all non-border
interfaces on routers when you deploy an IPv6 BIDIR-PIM domain.
IMPORTANT:
All interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 BIDIR-PIM:
Step
1. Enter system view.
2. Enable
routing and enter MRIB view.
3. Return to system view.
4. Enter interface view.
5. Enable IPv6 PIM-SM.
6. Return to system view.
7. Enter IPv6 PIM view
8. Enable IPv6 BIDIR-PIM
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling BSM semantic fragmentation
Disabling BSM forwarding out of incoming
Command
system-view
ipv6
IPv6 multicast
[
vpn-instance-name ]
quit
interface
interface-number
ipv6 pim sm
quit
ipv6
vpn-instance-name ]
bidir-pim enable
Remarks
Skip the task of configuring a BSR on an IPv6
network without C-RPs.
N/A
N/A
N/A
multicast routing
vpn-instance
interface-type
pim [ vpn-instance
350
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
N/A
N/A
By default, IPv6 PIM-SM is
disabled.
N/A
N/A
By default, IPv6 BIDIR-SM is
disabled.