Setting The 802.1P Priority For Mld Messages - HP MSR1002-4 Configuration Manual

Step
3. Configure the source IPv6
address for MLD general
queries.
4. Configure the source IPv6
address
multicast-address-specific
queries.
5. Configure the source IPv6
address for MLD reports.
6. Configure the source IPv6
address
messages.

Setting the 802.1p priority for MLD messages

When congestion occurs on outgoing ports of the Layer 2 device, it forwards MLD messages in their
802.1p priority order, from highest to lowest. You can assign a higher 802.1p priority to MLD
messages that are created or forwarded by the device.
You can configure the 802.1p priority of MLD messages for all VLANs in MLD-snooping view or for a
VLAN in VLAN view. For a VLAN, the VLAN-specific configuration takes priority over the global
configuration.
Command
mld-snooping
source-ip ipv6-address
for MLD
mld-snooping
source-ip ipv6-address
mld-snooping report source-ip
ipv6-address
mld-snooping done source-ip
for MLD done
ipv6-address
general-query
special-query
270
Remarks
By default, the source IPv6
address of MLD general queries
is the IPv6 link-local address of
the current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
link-local address of
multicast-address-specific
queries is one of the following:
•
The source address of MLD
general queries if the MLD
snooping querier
received MLD
queries.
•
The IPv6 link-local address
of the current VLAN interface
if the MLD snooping querier
does not receive an MLD
general query.
•
FE80::02FF:FFFF:FE00:000
1 if the MLD snooping
querier does not receive an
MLD general query and the
current VLAN interface does
not have an IPv6 link-local
address.
By default, the source IPv6
address of MLD reports is the
IPv6 link-local address of the
current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
address of MLD done messages
is the IPv6 link-local address of
the current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address
FE80::02FF:FFFF:FE00:0001.
is
MLD
has
general
is
is