Msdp Configuration Examples; Pim-Sm Inter-Domain Multicast Configuration - HP MSR1002-4 Configuration Manual

MSDP configuration examples

This section provides examples of configuring MSDP on routers.

PIM-SM inter-domain multicast configuration

Network requirements
As shown in
•
OSPF runs within AS 100 and AS 200. BGP runs between the two ASs.
•
Each PIM-SM domain has a minimum of one multicast source or receiver.
Set up MSDP peering relationships between the RPs in the PIM-SM domains to share multicast
source information among the PIM-SM domains.
Figure 53 Network diagram
AS 100
Router A
Table 13 Interface and IP address assignment
Device
Router A
Router A
Router A
Router B
Router B
Router B
Router C
Router C
Router C
Figure 53:
Receiver
Source 1
GE1/0/2
Router B
GE1/0/2
Loop0
PIM-SM 1
MSDP peers
Interface IP address
GE1/0/1 10.110.1.2/24
GE1/0/2 10.110.2.1/24
GE1/0/3 10.110.3.1/24
GE1/0/1 10.110.1.1/24
GE1/0/2 192.168.1.1/24
Loop0 1.1.1.1/32
GE1/0/1 10.110.4.1/24
GE1/0/2 192.168.3.1/24
GE1/0/3 192.168.1.2/24
AS 200
Receiver
Loop0
Router E
GE1/0/1
GE1/0/2
PIM-SM 3
PIM-SM 2
GE1/0/2
GE1/0/3 GE1/0/1
Router C
Loop0
Device
Router D
Router D
Router E
Router E
Router E
Router F
Router F
Source 1
Source 2
159
Router F
GE1/0/1
GE1/0/1
Router D
Source 2
Interface IP address
GE1/0/1 10.110.4.2/24
GE1/0/2 10.110.5.1/24
GE1/0/1 10.110.6.1/24
GE1/0/2 192.168.3.2/24
Loop0 3.3.3.3/32
GE1/0/1 10.110.6.2/24
GE1/0/2 10.110.7.1/24
— 10.110.2.100/24
— 10.110.5.100/24