Configuring A Port As A Simulated Member Host; Enabling Fast-Leave Processing - HP MSR1002-4 Configuration Manual

Step
3. Configure the port as a static
port.

Configuring a port as a simulated member host

When a port is configured as a simulated member host, it is equivalent to an independent host in the
following ways:
•
It sends an unsolicited MLD report when you complete the configuration.
•
It responds to MLD general queries with MLD reports.
•
It sends an MLD done message when you remove the configuration.
The version of MLD running on the simulated member host is the same as the version of MLD
snooping running on the port. The port ages out in the same ways as a dynamic member port.
To configure a port as a simulated member host:
Step
1. Enter system view.
2. Enter
interface view or Layer 2
aggregate interface view.
3. Configure the port as a
simulated member host.

Enabling fast-leave processing

This feature enables the device to immediately remove a port from the forwarding entry for an IPv6
multicast group when the port receives a done message.
Configuration restrictions and guidelines
When you enable fast-leave processing, follow these restrictions and guidelines:
•
Do not enable fast-leave processing on a port that have multiple receiver hosts attached in a
VLAN. If fast-leave processing is enabled, the remaining receivers cannot receive IPv6
multicast data for a group after a receiver leaves that group.
•
You can enable fast-leave processing globally for all ports in MLD-snooping view or for a port in
interface view. For a port, the port-specific configuration takes priority over the global
configuration.
Configuration procedure
To enable fast-leave processing globally:
Command
•
•
Command
system-view
Layer 2 Ethernet
interface
interface-number
mld-snooping
ipv6-group-address [ source-ip
ipv6-source-address
vlan-id
Configure the port as a static
member port:
mld-snooping static-group
ipv6-group-address
[ source-ip
ipv6-source-address ] vlan
vlan-id
Configure the port as a static
router port:
mld-snooping
static-router-port vlan
vlan-id
interface-type
host-join
] vlan
266
Remarks
By default, a port is not a static
member port or a static router
port.
Remarks
N/A
N/A
By default, the port is not a
simulated member host.