Anycast Rp Configuration - HP MSR1002-4 Configuration Manual

# Verify that receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data from Source 1 and
Source 2 to a multicast group. (Details not shown.)

Anycast RP configuration

Network requirements
As shown in
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can
initiate a join process to their respective RPs that are topologically closest to them.
Configure the router IDs of Router B and Router D as 1.1.1.1 and 2.2.2.2, respectively. Set up an
MSDP peering relationship between Router B and Router D.
Figure 55 Network diagram
Receiver
Host A
MSDP peers
Table 15 Interface and IP address assignment
Device
Source 1
Source 2
Router A
Router A
Router B
Router B
Router B
Router B
Router B
Router B
Figure 55, OSPF runs within the domain to provide unicast routes.
Source 1
Router A
GE1/0/1
Router B
GE1/0/1
Loop10
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
GE1/0/1 10.110.5.1/24
GE1/0/2 10.110.2.2/24
GE1/0/1 10.110.1.1/24
GE1/0/2 10.110.2.1/24
GE1/0/3 192.168.1.1/24
Loop0 1.1.1.1/32
Loop10 3.3.3.3/32
Loop20 10.1.1.1/32
Source 2
Router C
GE1/0/1
Router D
GE1/0/1
Loop10
PIM-SM
Device
Router C
Router C
Router D
Router D
Router D
Router D
Router D
Router D
Router E
Router E
168
Router E
Receiver
Host B
Interface IP address
GE1/0/1 192.168.1.2/24
GE1/0/2 192.168.2.2/24
GE1/0/1 10.110.3.1/24
GE1/0/2 10.110.4.1/24
GE1/0/3 192.168.2.1/24
Loop0 2.2.2.2/32
Loop10 4.4.4.4/32
Loop20 10.1.1.1/32
GE1/0/1 10.110.6.1/24
GE1/0/2 10.110.4.2/24