Anycast Rp Configuration - HP MSR2003 Configuration Manual

1
Peer address
10.110.1.1
# Display brief information about MSDP peers on Router G.
[RouterG] display msdp brief
Configured
1
Peer address
10.110.2.1
# Verify that receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data from Source 1 and
Source 2 to a multicast group. (Details not shown.)

Anycast RP configuration

Network requirements
As shown in
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can initiate
a join process to their respective RPs that are topologically nearest to them.
Configure the router IDs of Router B and Router D as 1.1.1.1 and 2.2.2.2, respectively. Set up an MSDP
peering relationship between Router B and Router D.
Figure 54 Network diagram
1 0
State Up/Down time
Established 01:07:09
Established Listen
1 0
State Up/Down time
Established 00:16:40
Figure 54, OSPF runs within the domain to provide unicast routes.
0 0
AS SA count
? 8
Connect Shutdown
0 0
AS SA count
? 13
161
0
Reset count
0
Disabled
0
Reset count
0