Winding The Hook Thread - Dürkopp Adler D888 e-con Operating Instructions Manual

Operation
Operating Instructions D888 e-con - 00.0 - 12/2023
Important:
Check the thread length.
If the loose thread end is too long, the thread may be caught by
the hook and cause a disturbance. If the loose thread end is too
short, the machine cannot start sewing.
4.6

Winding the hook thread

WARNING
Risk of injury from needle tip and moving parts!
Puncture, cutting and crushing possible.
Turn off the machine before threading the thread.
The hook thread can be wound on without sewing.
Important
Never use the winder without a bobbin. If using it without a bobbin,
you run the risk of the thread winding itself around the bobbin
shaft, which may cause damage to the winder.
To wind the hook thread:
1. Fit the thread reel on the reel stand.
The unwinding bracket must stand directly above the thread
reel.
2. Feed the thread from the rear to the front through the thread
guide on the unwinding bracket.
35