Fc Interface Commands; Bandwidth; Default - HP 5920 Series Command Reference Manual

<Sysname> system-view
[Sysname] fcoe-mode fcf
# Convert the switch operating in FCF mode to NPV mode.
[Sysname] undo fcoe-mode
All current FC configuration will be lost. Continue? [Y/N]:y
[Sysname] fcoe-mode npv
Related commands
display fcoe-mode

FC interface commands

bandwidth

Use bandwidth to configure the expected bandwidth of an FC interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth

Default

The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
FC interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth of an interface affects the link costs in FSPF. You can control the route selection
by configuring the expected bandwidth.
Examples
# Configure the expected bandwidth of interface FC 1/0/1 as 50 kbps.
<Sysname> system-view
[Sysname] interface fc 1/0/1
[Sysname-Fc1/0/1] bandwidth 50
default
Use default to restore the default settings for an FC interface.
Syntax
default
3