Fip-Snooping Fc-Map; Fip-Snooping Port-Mode - HP 5920 Series Command Reference Manual

<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] fip-snooping enable

fip-snooping fc-map

Use fip-snooping fc-map to configure an FC-MAP value for a VLAN.
Use undo fip-snooping fc-map to restore the default.
Syntax
fip-snooping fc-map fc-map
undo fip-snooping fc-map
Default
The FC-MAP value for a VLAN is 0x0EFC00.
Views
VLAN view
Predefined user roles
network-admin
Parameters
fc-map: Specifies an FC-MAP value in the range of 0x0EFC00 to 0x0EFCFF.
Usage guidelines
You can use the fcoe fcmap command to configure the FC-MAP value in a frame sent out of an FCF switch.
You can use the fip-snooping fc-map command to configure an FC-MAP value for a VLAN on a Transit
switch.
When an Ethernet interface in the FIP snooping VLAN receives a frame from the FCF switch, the following
rules apply:
If the FC-MAP value in the incoming frame is the same value that is configured for the FIP snooping
•
VLAN, the Ethernet interface forwards the frame.
If the FC-MAP value in the incoming frame is different from the value that is configured for the FIP
•
snooping VLAN, the Ethernet interface drops the frame.
Examples
# Configure an FC-MAP value of 0x0EFCFF for VLAN 10.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan 10] fip-snooping fc-map 0efcff
Changing the FC-MAP will flap all interfaces. Continue[Y/N]?
Related commands
fcoe fcmap

fip-snooping port-mode

Use fip-snooping port-mode to configure the mode of an interface on the Transit switch.
137