San-Aggregation Group - HP 5920 Series Command Reference Manual

If you do not specify the san-aggregation keyword, this command clears statistics for all interfaces.
If you specify the san-aggregation keyword, this command clears statistics for all FC aggregate
interfaces.
If you specify an FC aggregate interface, this command clears statistics for the specified FC aggregate
interface.
Examples
# Clear statistics for FC aggregate interface 3.
<Sysname> reset counters interface san-aggregation 3
Related commands
display interface san-aggregation

san-aggregation group

Use san-aggregation group to assign an FC interface to an FC aggregation group.
Use undo san-aggregation group to remove an FC interface from an FC aggregation group.
Syntax
san-aggregation group group-number
undo san-aggregation group
Default
An FC interface is not assigned to any FC aggregation group.
Views
FC interface view
Predefined user roles
network-admin
Parameters
group-number: Specifies an FC aggregation group by its group number. An FC aggregation group
uniquely corresponds to an FC aggregate interface, and they are numbered the same.
Usage guidelines
An FC interface can be assigned to only one FC aggregation group.
After an FC interface is assigned to an FC aggregation group, its operating mode, trunk mode, trunk
VSAN, and access VSAN configurations are cleared. Also, you cannot configure these configurations for
a member interface. After the FC interface is removed from the FC aggregation group, these
configurations are not restored, and the default settings of these configurations are used.
An FC aggregation group can have a maximum of eight member interfaces.
Examples
# Assign FC interface FC 1/0/1 to FC aggregation group 2.
<Sysname> system-view
[Sysname] interface fc 1/0/1
[Sysname-Fc1/0/1] san-aggregation group 2
Current FC mode, trunk mode, trunk VSAN, and access VSAN configuration of the in
37