D-Link DES-3250TG User Manual page 78

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
The IP address may alternatively be set using the
Command Line Interface (CLI) over the console serial port
as follows:
1. Starting at the command line prompt, enter
the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the
x's represent the IP address to be assigned to
the IP interface named System and the y's
represent the corresponding subnet mask.
2. Alternatively, you can enter the commands
config
xxx.xxx.xxx.xxx/z
prompt. Where the x's represent the IP address
to be assigned to the IP interface named
System
corresponding number of subnets in CIDR
notation.
Using this method, the switch can be assigned an IP address
and subnet mask that can then be used to connect a
management station to the switch's Web-based management
agent.
Saving Configuration Changes
Clicking the Apply button makes any configuration change
active, but only for the current session. If the switch is
restarted (rebooted) without entering the configuration changes
into the non-volatile RAM (NV-RAM), the configuration changes
will be lost.
To enter configuration changes into the switch's non-volatile
RAM, select Save Changes from the Maintenance menu. Click
on the Save Configuration button to enter the current
configuration into NV-RAM. The configuration will then be
loaded into the switch's memory when it is restarted.
ipif System
at the command
and the z represents
70
ipaddress
line
the