D-Link DES-3250TG User Manual page 45

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
Within the switch, different PVIDs mean different VLANs.
(remember that two VLANs cannot communicate without an
external router). So, VLAN identification based upon the PVIDs
cannot create VLANs that extend outside a given switch (or
switch stack).
Every physical port on a switch has a PVID. 802.1Q ports are
also assigned a PVID, for use within the switch. If no VLANs
are defined on the switch, all ports are then assigned to a
default VLAN with a PVID equal to 1. Untagged packets are
assigned the PVID of the port on which they were received.
Forwarding decisions are based upon this PVID, insofar as
VLANs are concerned. Tagged packets are forwarded according
to the VID contained within the tag. Tagged packets are also
assigned a PVID, but the PVID is not used to make packet
forwarding decisions, the VID is.
Tag-aware switches must keep a table to relate PVIDs within
the switch to VIDs on the network. The switch will compare the
VID of a packet to be transmitted to the VID of the port that is
to transmit the packet. If the two VIDs are different, the switch
will drop the packet. Because of the existence of the PVID for
untagged packets and the VID for tagged packets, tag-aware
and tag-unaware network devices can coexist on the same
network.
A switch port can have only one PVID, but can have as many
VIDs as the switch has memory in its VLAN table to store them.
Because some devices on a network may be tag-unaware, a
decision must be made at each port on a tag-aware device
before packets are transmitted – should the packet to be
transmitted have a tag or not? If the transmitting port is
connected to a tag-unaware device, the packet should be
untagged. If the transmitting port is connected to a tag-aware
device, the packet should be tagged.
37