Korg KROSS Operation Manual page 142

Appendices
Error in reading from media
Meaning: An error occurred while reading data from media.
This error may also appear when data is being written to
media by a Save or Copy operation. To solve this problem:
• Execute the reading procedure once again. If the same
error occurs, it is possible that the data on the media has
been damaged.
Error in writing to media
Meaning: A verification error occurred while writing data to
a media. To solve this problem:
• It is possible that the media has been physically
damaged. Try another media. Avoid using the media that
produced the error.
F
File already exists
Meaning: When executing a File Rename procedure, a file
of the same name already exists on the media.
• Either delete the existing file, or specify a different
name.
File contains unsupported data
Meaning: You attempted to load a WAVE file or .KEP file
of a format that is not supported by the KROSS.
• If possible, use a computer to convert the file to a format
that the KROSS supports, and then load it.
File is read-only protected
Meaning: You attempted to write or delete a file, but the file
has a read-only attribute.
Meaning: You attempted to save a file with the same name
as a read-only file that already exists on the media.
• Save the file with a different name.
Meaning: After using a computer etc. to lock the KORG
folder, KROSS2 folder, or DATA folder, you then attempted
to save using the Media mode of the KROSS.
• Use your computer etc. to unlock these folders.
File unavailable
Meaning: The data from .KEP file is invalid. It is possible
that the .KEP file from SD card has been damaged.
File/path not found
Meaning: When operating the audio recorder, or when
executing the Delete utility function of Media mode, the
specified file did not exist.
• Check the file.
I
Illegal file description
Meaning: You used an invalid file name when attempting to
save or export a file.
• Change the filename you are specifying. Filenames not
permitted by MS-DOS cannot be used as a filename.
Illegal SMF data
Meaning: You attempted to load a file that was not a
Standard MIDI File.
Illegal SMF division
Meaning: You attempted to load a Standard MIDI File that
was timecode-based.
136
Illegal SMF format
Meaning: You attempted to load a Standard MIDI File of a
format other than 0 or 1.
M
Measure number over limit
Meaning: The attempted edit procedure would cause the
track length to exceed 999 measures.
• Delete unnecessary measures.
Measure size over limit
Meaning: When loading a Standard MIDI File, the number
of events in a measure exceeded the maximum
(approximately 65,535 events).
Meaning: The attempted edit procedure would cause the
maximum number of events in a measure (approximately
65,535) to be exceeded.
To solve either of these problems:
• Use event editing etc. to delete unwanted data.
Media busy
Meaning: SD card access was not fast enough to keep up
with recording or playback.
• As you repeatedly delete and write files, the file access
efficiency may decline. In this case, you may be able to
improve the situation by copying the KORG folder from
the SD card to your computer, then formatting the SD
card on the KROSS, and finally writing the KORG
folder from your computer back to its original location.
If this does not improve the situation, switch to a
different SD card.
Media not formatted
Meaning: The media is unformatted.
• In the Media mode Utility page, execute the Format
function on the media.
Media unavailable
Meaning: You selected a media source that does not allow
writing.
Media write protected
Meaning: The audio recorder or Media mode is attempting
to write data to media that is write-protected.
• Disable the write protect setting of the media, and
execute the audio recorder operation or the command
once again.
Memory full
Meaning: When editing a song, or track in Sequencer mode,
the total data of all songs has used up all of the sequence data
memory, and further editing is not possible. To solve this
problem:
• Delete other song data etc. to regain free memory.
Meaning: While realtime recording in Sequencer mode,
there is no more free memory to accommodate the recorded
data, so recording has been forcibly halted. To solve this
problem:
• Delete other song data etc. to regain the amount of free
memory.