Powering The Tester; Localizing The Tester - Fluke DTX-CLT CertiFiber User Manual

DTX-CLT CertiFiber Optical Loss Test Set
Users Manual

Powering the Tester

•
You may charge the battery when it is attached or
detached from the tester. Figure 8 shows how to
remove the battery.
•
The battery charges fully in about 4 hours with the
tester off. A fully-charged battery lasts for at least 12
hours of typical use.
The battery will not charge at temperatures outside
of 0 °C to 45 °C (32 °F to 113 °F). The battery
charges at a reduced rate between 40 °C and 45 °C
(104 °F and 113 °F).
•
The battery status icon (
corner of main screens shows the battery's charge
level. The smart remote's LEDs show the smart
remote's battery status at the end of the power-up
cycle, as shown in Figure 9.
•
For additional battery information, connect the main
tester and smart remote through link adapters, turn
the rotary switch to SPECIAL FUNCTIONS; then select
Battery Status. See page 64 for information on
retraining the battery gauge.
14
Note
) near the upper-right
•
If the battery does not reach full charge within 6 hours,
the battery LED flashes red. Verify that the battery was
within the temperature range given above during
charging and that the correct ac adapter was used.
Disconnect then reconnect ac power and try charging
the battery again. If the battery does not charge the
second time, retrain the battery gauge. See page 64.

Localizing the Tester

Local settings include Language, Date, Time, Numeric
Format, Length Units, and Power Line Frequency.
1 Turn the rotary switch to SETUP.
Use D to highlight Instrument Settings at the
2
bottom of the list; then press H.
C D
3 Use and to find and highlight Language on
the bottom of tab 2; then press
Use D to highlight the desired language; then
4
press H.
Use the arrow keys and H to find and change other
5
local settings on tabs 2, 3, and 4 under Instrument
Settings.
H
.