Factory Calibration; Updating The Tester's Software - Fluke DTX-CLT CertiFiber User Manual

DTX-CLT CertiFiber Optical Loss Test Set
Users Manual

Factory Calibration

The tester requires calibration at a service center once a
year to ensure that it meets or exceeds the published
accuracy specifications. Contact an authorized Fluke
Networks Service Center for information on getting your
tester calibrated.

Updating the Tester's Software

Keeping your tester's software current gives you access to
new features and the latest test limits.
To see the software version installed in your tester or smart
remote, connect the testers through link adapters, turn the
rotary switch to SPECIAL FUNCTIONS; then select Version
Information.
To get a software update, download the update from the
Fluke Networks website or contact Fluke Networks to get
the update by other means.
W
Caution
To avoid unexpected loss of power, connect the ac
adapter to the tester when updating the software.
62
Changes to the update procedure may be posted
on the DTX CableAnalyzer software page on the
Fluke Networks website.
Updating with a PC
1 Install the latest version of LinkWare software on your
PC.
2 Download the DTX-CLT CertiFiber update file from
the Fluke Networks website, or contact Fluke
Networks to get the update by other means. Save the
file to your hard drive.
3 Make the connections shown in Figure 28. Turn on the
tester and the smart remote.
4 Select Utilities > DTX Utilities > Software Update from
the LinkWare menu, locate and select the .dtx (DTX
update) file; then click Open.
5 When the tester is updated, it reboots, then prompts
you about updating the smart remote's software.
K
Press OK to update the smart remote's software.
6 To verify the update, turn the rotary switch to SPECIAL
FUNCTIONS; then select Version Information.
Note