Table of Contents
Advertisement
S3C6400X RISC MICROPROCESSOR
AutoLoadEnable
LCDPathEnable
Interlace
Wide/Narrow
[11:10]
SRC420
INTEN
POSTINT
IRQ_LEVEL
OutRGBFormat
InRGB
INTERLEAVE
InRGBFormat
InYCbCrFormat_L
SB
Caution:: [9] bit is reserved.
[14]
AutoLoadEnalbe. 0 for Per Frame mode and 1 for Free Run mode
[13]
Out FIFO Mode Enable. 1 for FIFO mode and 0 for DMA mode
[12]
Output scan method selection register only when FIFO mode
(LCDPathEnable =1). 1 for Interlace scan and 0 for progressive
scan. In DMA mode (LCDPathEnable = 0), progressive scan is
executed irrespective of the value given.
Select color space conversion equation from YCbCr to RGB
according to input value range. 2'10 for YCbCr Wide range and
2'01 for YCbCr Narrow range
0 for YCbCr422 and 1 for YCbCr420 source format. It is valid only
[8]
for YCbCr source image (i.e. InRGB = 0)
Interrupt Enable. It determines whether the POSTINT signal is
[7]
asserted or not, when the processing of the current frame is
finished. 0: disable, 1 : enable.
Interrupt Pending Bit. If INTEN is enabled, it is automatically
[6]
asserted right after finishing operation of the current frame. It must
be cleared by interrupt service routine. 0: disable, 1: enable.
It determines the interrupt generation scheme. 1 for level interrupt.
[5]
(must be 1)
It determines the output format of destination image. 0 for 16-bit
[4]
(565 format) RGB and 1 for 24-bit RGB.
It indicates the input color space of source image. 0 for YCbCr or 1
[3]
for RGB.
It indicates the data format of YCbCr. 0 for Non-Interleaved format
(Each component of Y, Cb and Cr is access by the word). 1 for
[2]
Interleaved format (All components of Y, Cb and Cr are mixed
inside single word). It should be 1 when source image is RGB data
(or InRGB =1).
If the source image is in RGB color space (or InRGB=1), it
indicates the data format of graphic image. 0 for 16-bit (565
[1]
format) and 1 for 24-bit. Otherwise (or InRGB=0), it should be
remains to 1.
It determines the LSB of byte organization of word data when the
[0]
source image is interleaved YCbCr format. For more information
refer to Fig.15-2(b) .
Preliminary product information describe products that are in development,
for which full characterization data and associated errata are not yet available.
Specifications and information herein are subject to change without notice.
POST PROCESSOR
0
0
0
2'b10
1
0
0
0
1
0
0
1
0
15-19
Advertisement
Table of Contents
