Fujitsu SPARC Enterprise M3000 Product Notes page 56

XCP Issues Fixed in Releases Earlier Than XCP 1112 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O
111005-001
RTIF1- O O
111028-001
42 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1112 • May 2012
M8000
M9000 Description
O M4000/M5000 servers:
When the system board is mounted
with the onboard I/O device, if you use
the addboard(8) or moveboard(8)
command to add or move it by DR,
operation may fail.
M8000/M9000 servers:
When the system board is mounted
with one or more PCI cards, if you use
the addboard(8) or moveboard(8)
command to add or move it by DR,
operation may fail.
However, when it is mounted with the
IOUA card only, this event does not
occur.
In either case, the following message
appears on the destination domain
console of the system board addition or
move:
interpreter[xxxx]: ABORT: Bus
Error: Fault Addr: 0xXXXXXXXX
efdaemon[xxx]: Wait pid: xxxx
status: xxx
WARNING: IKP: Unable to probe
PCI leaf (x-x-x)
O In the setemailreport(8),
setsmtp(8) or setupplatform(8)
command, any of the following
characters in the email address will
result in an error.
!#$%&'*+/=?^`{|}~
Workaround
M4000/M5000 servers:
No workaround is available.
M8000/M9000 servers:
No workaround is available.
Do not specify these characters in the
email address.