Fujitsu SPARC Enterprise M3000 Product Notes page 52

XCP Issues Fixed in Releases Earlier Than XCP 1112 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1-
090427-003
RTIF1- O O
090427-004
RTIF1- O O
090430-001
RTIF1- O O
090508-001
RTIF1- O O
090729-001
38 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1112 • May 2012
M8000
M9000 Description
O After changed the SNMP configuration,
when the XSCF switching occurred, the
SNMP function may be disabled.
O In the setting of the LDAP server, the
number of characters which can be
specified differs between XSCF Web
and XSCF Shell. On XSCF Web, you can
enter up to 128 characters.
O After you set https (using the self
certificate authority) by XSCF and
created a web server certificate, https is
not enabled.
O In a domain mounted with the 10
Gigabit Ethernet card (SE0X7HE1F),
when you set the OpenBoot PROM
environmental variable diag-switch?
to true, the following warning
message appears on the console; and at
the same time, "Msg: Device error
(FCode informed error)" is
recorded in the error log.
WARNING: /pci@7,700000: FCODE
map-in doesn't match decoded
register type;
And when you execute the
showstatus(8) command, "Degraded"
might be indicated to the FRU which
has installed the relevant card.
O When you use the sethttps(8)
command to create a self-signed web
server certificate, if the number of
characters specified in a parameter
exceeds 100, it might result in an
internal error and you might fail to
create the certificate.
Workaround
No workaround is available.
In case this event occurred, the
following command may restore the
function.
setsnmp disable
setsnmp disable (run "setsnmp
disable" twice)
setsnmp enable
To set 129 characters or more, use XSCF
Shell.
To set the self certificate authority, do
not specify a blank character.
The entire output can be safely ignored.
To avoid these outputs, execute the
following command at the ok prompt
and set the OpenBoot PROM
environmental variable diag-switch?
to false.
setenv diag-switch? false
Specify up to 100 characters in the
parameter and execute the sethttps(8)
command again.