Fujitsu SPARC Enterprise M3000 Product Notes page 38

XCP Issues Fixed in Releases Earlier Than XCP 1112 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O
070904-006
RTIF1- O
070912-001
RTIF1- O
070914-001
RTIF1- O
070914-002
RTIF1- O
070914-003
RTIF1- O
070914-005
RTIF1- O
070914-006
24 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1112 • May 2012
M8000
M9000 Description
O While executing the domain power-on,
domain reset or DR, in case the XSCF
reset occurred, the process may be
aborted in some or all of the XSB.
O If an invalid SMTP server is configured,
a subsequent attempt to disable e-mail
service (using the setemailreport
CLI) may block for up to 30 minutes.
O While executing the firmware update
by using the flashupdate(8)
command or BUI, when the import of
XCP executed by using the
getflashimage(8) command or BUI,
the firmware update aborts.
O When the XSCF switching performed,
the monitor message doesn't show the
number of XSCF unit which turned
active.
O When the XSCF switching performed,
there may be "SCF: Board control
error (DMA timeout)" stored in the
error log.
O On the XSCF Web, when using Internet
Explorer 7, on the [User Accounts]
screen, User Local Accounts doesn't
show the Status of each user.
O When you set the XSCF user account
name to the maximum 32 characters,
you can log in, but then, when you
execute the XSCF Shell or operate the
XSCF Web, "Permission denied"
occurs.
Workaround
Execute the domain reset one more
time, or power off the domain and then
power on again.
Wait for the CLI to complete. The rest of
the system will function normally
during this time.
• The CLI can also be aborted by ^C.
Note that the operation (disabling
email report) is completed, even if ^C
is used.
• showemailreport can be used to
confirm that the email service has
been disabled.
Do not execute the import of XCP by
using the getflashimage(8) command
or BUI, while executing the firmware
update.
Execute the showhardconf(8)
command to refer to the state of XSCF
unit.
No workaround is available.
This message can be safely ignored.
None available at this time.
Use up to 31 characters to set the XSCF
user account name.