3.4.10. Ether Test
Preprocessing
Acquisition of base address
Initialization of PCI Configuration(bus master enable)
Acquisition of MAC Address
3.4.10.1. Self Test
Check the LAN chip internally, and whether network cable is connected or not. Diagnostic program can detect
network communication speed if connected to HUB.
Screen of LCD
***** Self Test *****
Screen of LCD
***** Self Test *****
Cable check
Test done. Press any key.
3.4.11. USB test
The target USB devices are as below;
MSR Unit
ID Block
Dallas Key Reader Unit
Fingerprint Sensor Unit
NOTE:
About generic USB Mass Storage device and USB Keyboard with USB HUB, diagnostic program sometimes
cannot detect them. So please use the above listed devices as the target USB device for this test.
Screen of LCD
***** Ether Test.*****
***** Ether Test.*****
100BASE-TX
Full Speed
JS-925MG-010
Full Speed
JS-925DP-010
Full Speed
JS-925FS-010
50
1(OK)
2(NG)
EXIT
Magnetic strip reader module
Dallas KEY Reader module
Fingerprint Sensor module