Avaya 1140E Software User's Manual page 72

Configuring the Avaya 1140E IP Deskphone
Figure 20: Headset screen
The following table describes the configuration options on the Headset screen.
Option
Active Headset Device
Wired Headset Type
Enable HID Commands
MHS Headset Type
August 2017
Select the active headset device; either USB or Wired.
Note:
The headset can be selected before it is attached (wired or
USB).
Items below the Active Headset Device field are dimmed, if either
USB headset is not selected or if the attached headset is not one
of the Human Interface Device (HID) supported headset types.
Select the type of wired headset you required.
• Headset Type 1 (Generic narrow band)
• Headset Type 2 (Wideband)
• Headset Type 3 (Wideband)
Enable HID Commands only if USB headset is selected.
The checkbox is used to enable the HID commands of supported
headsets to allow the IP Deskphone to run in generic mode 1
operation, supporting both USB audio and HID commands. The
configuration is ignored for non-supported USB headsets.
Choose an MHS Headset Type only if Avaya headset adapter is
detected.
This list contains the different wired headset types that can be
attached to the Avaya Enhanced or Mobile Adapters for loss plan
adjustment. The command is ignored for other types of USB
Avaya 1140E IP Deskphone with SIP Software User Guide
Comments on this document? infodev@avaya.com
Function
Table continues...
72