Parameter List - Mitsubishi MR-JE-10B Instruction Manual

5. PARAMETERS
5. PARAMETERS
CAUTION

5.1 Parameter list

Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition, such as failing to start up the servo amplifier.
Changing the values of the parameters for manufacturer setting
Setting a value out of the range
Changing the fixed values in the digits of a parameter
When you write parameters with the controller, make sure that the control axis
No. of the servo amplifier is set correctly. Otherwise, the parameter settings of
another axis may be written, possibly causing the servo amplifier to be an
unexpected condition.
POINT
When you connect the amplifier to a servo system controller, servo parameter
values of the servo system controller will be written to each parameter.
Some parameters and their ranges may not be configured depending on the
servo system controller model, servo amplifier software version, and MR
Configurator2 software version. For details, refer to the servo system controller
user's manual. Check the software version of the servo amplifier with MR
Configurator2.
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: To enable the parameter value, power off the servo amplifier for 1 s or longer
and power on the amplifier or reset the controller after setting the parameter.
However, the time will be longer depending on a setting value of [Pr. PF25
Instantaneous power failure tough drive - Detection time] when "instantaneous
power failure tough drive selection" is enabled in [Pr. PA20].
**: To enable the parameter value, power off the servo amplifier for 1 s or longer
and power on the amplifier. However, the time will be longer depending on a
setting value of [Pr. PF25 Instantaneous power failure tough drive - Detection
time] when "instantaneous power failure tough drive selection" is enabled in
[Pr. PA20].
5 - 1