The Vpn Edit Screen - ZyXEL Communications P-793H v3 User Manual

The following table describes the fields in this screen.
Table 47 Security > VPN > Setup
LABEL
No.
Active
Name
Local Address
Remote
Address
Encap.
IPSec Algorithm This field displays the security protocols used for an SA.
Secure
Gateway IP
Modify
Apply
Cancel

13.3 The VPN Edit Screen

Click an Edit icon in the VPN Setup screen to edit VPN policies.
Chapter 13 VPN
DESCRIPTION
This is the VPN policy index number. Click a number to edit VPN policies.
This field displays whether the VPN policy is active or not. A Yes signifies that this
VPN policy is active. No signifies that this VPN policy is not active.
This field displays the identification name for this VPN policy.
This is the IP address(es) of computer(s) on your local network behind your P-79X.
The same (static) IP address is displayed twice when the Local Address Type
field in the VPN Setup - Edit screen is configured to Single.
The beginning and ending (static) IP addresses, in a range of computers are
displayed when the Local Address Type field in the VPN Setup - Edit screen is
configured to Range.
A (static) IP address and a subnet mask are displayed when the Local Address
Type field in the VPN Setup - Edit screen is configured to Subnet.
This is the IP address(es) of computer(s) on the remote network behind the
remote IPSec router.
This field displays N/A when the Secure Gateway Address field displays
0.0.0.0. In this case only the remote IPSec router can initiate the VPN.
The same (static) IP address is displayed twice when the Remote Address Type
field in the VPN Setup - Edit screen is configured to Single.
The beginning and ending (static) IP addresses, in a range of computers are
displayed when the Remote Address Type field in the VPN Setup - Edit screen
is configured to Range.
A (static) IP address and a subnet mask are displayed when the Remote Address
Type field in the VPN Setup - Edit screen is configured to Subnet.
This field displays Tunnel or Transport mode (Tunnel is the default selection).
Both AH and ESP increase P-79X processing requirements and communications
latency (delay).
This is the static WAN IP address or URL of the remote IPSec router. This field
displays 0.0.0.0 when you configure the Secure Gateway Address field in the
VPN-IKE screen to 0.0.0.0.
Click the Edit icon to go to the screen where you can edit the VPN configuration.
Click the Remove icon to remove an existing VPN configuration.
Click this to save your changes and apply them to the P-79X.
Click this return your settings to their last saved values.
P-79X Series User's Guide
131